1100 h18 aluminum foil for aluminum composite panel
Alloy: 1100
Temper: H18
Thickness: 0.14-0.20mm
Width: 900_1400mm
Length: 900_1400mm
Packing: Export standard, wooden pallet or wooden case;
Origin: China
Payment Terms: T/T, irrevocable L/C at sight
Lead Time: Within 25 days
Application: Using for printed circuit board.
Remark: Specific requirement of alloy, temper or specification can be discussed at your request.
The aluminum composite panel is a composite of multiple layers of materials, the upper and lower layers are high-purity aluminum alloy panels, the middle is a non-toxic low-density polyethylene (PE) core board, and a protective film is pasted on the front side.
The common specification of aluminum composite panel is 1.22Mx2.44M, and the thickness is 3-5MM. Among them, aluminum foil or aluminum skin is one of the raw materials of aluminum composite panel. Its thickness is usually expressed by wire. Aluminum composite panel uses 1100 aluminum foil with a thickness of 8 There are two types of silk: indoor and outdoor according to the purpose. If it is an outdoor board, it can be customized, and the length can be 6M.
The common aluminum foil roll thicknesses for general aluminum composite panel are as follows:
Aluminum used for facade aluminum composite panel uses 0.20 mm, 0.30 and 0.40 mm, and 0.50 mm. Among them, 0.30 and 0.40 are more common, so the wind pressure resistance is better.
Aluminum foil coils for aluminum composite panel on the inner façade, the thickness of aluminum foil coils with structures of 0.15mm and 0.12-0.10mm is relatively wide.
Aluminum aluminium plate/sheet for PCB drilling entry |
|
Alloy |
Temper |
Specification(mm) |
|
Thickness |
Width |
Length |
Remarks |
|
1100 |
H18 |
0.14-0.20 |
1244 |
1092 1041 940 |
Produce various specifications according to customers' requirements |
|
|
|
1220 |
1067 1016 914 |
|
|
|
TECHNICAL DATA SHEET |
Alloy |
Si |
Fe |
Cu |
Mn |
Mg |
Cr |
Ni |
Zn |
Ti |
Other |
Al |
each |
total |
1100 |
Si +Fe:0.95 |
0.05-0.20 |
0.2 |
- |
- |
- |
0.1 |
- |
0.05 |
0.15 |
99.0 |
MECHANICAL PROPERTY |
Alloy |
Temper |
Thickness(mm) |
U.T.S(Mpa) |
Elongation(%) |
1100 |
H18 |
0.14-0.18 |
170-190 |
≥2 |
TOLERANCE |
Thickness(mm) |
Width(mm) |
Length(mm) |
Diagonal(mm) |
±0.005mm |
+1 -0 |
+1 -0 |
≤2 |